Investigating Effect of Bearing Length on Tensile Strength of 1045 Steel in Wire Drawing Operation
Abstract
Keywords
Kaynakça
- Gillström, P., & Jarl, M. (2007). Wear of die after drawing of pickled or reverse bent wire rod. Wear, 262(7–8), 858–867. https://doi.org/10.1016/j.wear.2006.08.016
- Korchunov, A., Gun, G., & Polyakova, M. (2014). Recovery effect in drawing of steel bar for sizing. Procedia Engineering, 81, 676–681. https://doi.org/10.1016/j.proeng.2014.10.059
- Nilsson, M., & Olsson, M. (2011). Tribological testing of some potential PVD and CVD coatings for steel wire drawing dies. Wear, 273(1), 55–59. https://doi.org/10.1016/j.wear.2011.06.020
- Sas-Boca, I. M., Tintelecan, M., Pop, M., Iluţiu-Varvara, D. A., & Mihu, A. M. (2017). The Wire Drawing Process Simulation and the Optimization of Geometry Dies. Procedia Engineering, 181, 187–192. https://doi.org/10.1016/j.proeng.2017.02.368
- Schade, P. (2006). Wire drawing failures and tungsten fracture phenomena. International Journal of Refractory Metals and Hard Materials, 24(4), 332–337. https://doi.org/10.1016/j.ijrmhm.2005.09.003
- Wei, D., Min, X., Hu, X., Xie, Z., & Fang, F. (2020). Microstructure and mechanical properties of cold drawn pearlitic steel wires: Effects of drawing-induced heating. Materials Science and Engineering A, 784, 139341. https://doi.org/10.1016/j.msea.2020.139341
- Xu, P., Liang, Y., Li, J., & Meng, C. (2019). Further improvement in ductility induced by the refined hierarchical structures of pearlite. Materials Science and Engineering A, 745, 176–184. https://doi.org/10.1016/j.msea.2018.12.069
Ayrıntılar
Birincil Dil
İngilizce
Konular
Makine Mühendisliği
Bölüm
Araştırma Makalesi
Yazarlar
Ekrem Çelik
0000-0002-2641-1049
Türkiye
Fatih Özen
*
0000-0002-2915-8456
Türkiye
Erdinç İlhan
0000-0002-3873-1680
Türkiye
Salim Aslanlar
0000-0001-6676-110X
Türkiye
Yayımlanma Tarihi
3 Aralık 2020
Gönderilme Tarihi
25 Ağustos 2020
Kabul Tarihi
10 Eylül 2020
Yayımlandığı Sayı
Yıl 2020 Cilt: 23 Sayı: 4